-Fully Machined clamp plates to ensure optimized clamping face.
-6″ wide base with 8″ clamping plates to allow for mold stability and greater clamping surface.
-Adjustable height for different mold sizes.
-Anti Marring plates to help reduce cosmetic wear of mold surfaces.
-Adjustable speed controller to optimize cylinder speed to operator preference.
-110-140 psi recommended for operation.
-Inline filter recommended to extend the life of the cylinders.
-Keep molds centered to get optimal clamping pressure.
-Remove air pressure from clamp after each use.
-Usage of the clamp can pinch hand, finger or ect. Using this clamp the operator/owner of the clamp takes full responsibility of usage of the device.
-Clean with compressed air and WD-40 only.
-Do not exceed 140 psi.
-Lubricate system with 1 drop of pneumatic tool oil per week of use.
***Frequent use may require more frequent lubrication.
***LUBRICATE WITH PNEUMATIC TOOL OIL ONLY***